Z-Uno is not reachable by the controller or other Z-Wave devices Z-Uno is too far from the controller or any other mesh capable Z-Wave device in the network → try to move Z-Uno closer to the controller.Your sketch prevents Z-Uno from handling button/Z-Wave operations (you did an infinite loop) → use rescue mode to disable your sketch.Your Z-Uno is not on the same frequency as your Z-Wave controller → please doublecheck in Arduino IDE settings and in controller settings.Triple press on Service Button is not fast enough → press the Service Button faster. ![]() ![]() There might be many reasons to fail inclusion: ![]() To make your experience better we have collected here some most frequent problems you can experience.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |